Honda Passport with Aluminum Wheels lug nut torque
GarageDex's lug nut torque data shows the 1995 to 2002 Honda Passport with Aluminum Wheels wheel lug nuts torque to 87 ft-lbs. Across the Honda lineup, that guide lists 12mm x 1.50 lug nuts.
Key takeaways
- Torque: 87 ft-lbs for the 1995 to 2002 model years.
- Tighten in a star (criss-cross) pattern so the wheel seats flat.
- Re-check torque after 50 to 100 miles.
- Aftermarket wheels or lug nuts can specify a different value - use the wheel maker's figure if it differs.
| Years | Torque | Pattern |
|---|---|---|
| 1995 to 2002 | 87 ft-lbs | Star pattern |
| Years | Thread size |
|---|---|
| 1980 to 2020 | 12mm x 1.50 |
| 1967 to 1980 | 12mm x 1.25 |
The guide below does not break out the Honda Passport with Aluminum Wheels separately - this is the general Honda thread size, same source.
Seat type (cone, mag, or ball) and hex size are not given per vehicle by this source - match them to the lug nut already on your wheel before ordering locks. Source: White Knight Wheel Accessories - 2020 Application Guide.
Tools for the job
These fit any vehicle. Lug nuts and wheel locks are vehicle-specific, so that link searches by your Honda Passport with Aluminum Wheels.
As an Amazon Associate we earn from qualifying purchases, at no extra cost to you.
How to torque Honda Passport with Aluminum Wheels wheels
- Hand-thread every lug nut, then snug them lightly with the wheel off the ground.
- Lower the car until the tire just touches and cannot spin.
- Set the wrench to 87 ft-lbs and tighten in a star pattern, skipping to the opposite nut each time.
- Lower fully, go around once more at the same setting.
- Re-check after 50 to 100 miles.
Other Honda models
Source: James Halderman - Lug Nut Torque Values 1995-2021. Torque values assume clean, dry threads and OEM wheels. Always confirm against your owner's manual, and re-check torque after the first 50 to 100 miles.