Mazda Millenia lug nut torque

GarageDex's lug nut torque data shows the 1995 to 2002 Mazda Millenia wheel lug nuts torque to 65 to 94 ft-lbs. Across the Mazda lineup, that guide lists 12mm x 1.50 lug nuts.

Shop torque wrenches A 1/2-inch click wrench covers every value on this page

Key takeaways

  • Torque: 65 to 94 ft-lbs for the 1995 to 2002 model years.
  • Tighten in a star (criss-cross) pattern so the wheel seats flat.
  • Re-check torque after 50 to 100 miles.
  • Aftermarket wheels or lug nuts can specify a different value - use the wheel maker's figure if it differs.
Mazda Millenia lug nut torque by year
YearsTorquePattern
1995 to 200265-94 ft-lbsStar pattern
Mazda Millenia lug nut thread size
YearsThread size
All model years12mm x 1.50

The guide below does not break out the Mazda Millenia separately - this is the general Mazda thread size, same source.

Seat type (cone, mag, or ball) and hex size are not given per vehicle by this source - match them to the lug nut already on your wheel before ordering locks. Source: White Knight Wheel Accessories - 2020 Application Guide.

Tools for the job

These fit any vehicle. Lug nuts and wheel locks are vehicle-specific, so that link searches by your Mazda Millenia.

As an Amazon Associate we earn from qualifying purchases, at no extra cost to you.

How to torque Mazda Millenia wheels

  1. Hand-thread every lug nut, then snug them lightly with the wheel off the ground.
  2. Lower the car until the tire just touches and cannot spin.
  3. Set the wrench to 65 to 94 ft-lbs and tighten in a star pattern, skipping to the opposite nut each time.
  4. Lower fully, go around once more at the same setting.
  5. Re-check after 50 to 100 miles.

Other Mazda models

Source: James Halderman - Lug Nut Torque Values 1995-2021. Torque values assume clean, dry threads and OEM wheels. Always confirm against your owner's manual, and re-check torque after the first 50 to 100 miles.