Bentley Brooklands lug nut torque
GarageDex's lug nut torque data shows the 2008 to 2010 Bentley Brooklands wheel lug nuts torque to 96 to 100 ft-lbs. Across the Bentley lineup, that guide lists 14mm x 1.50 wheel bolts.
Key takeaways
- Torque: 96 to 100 ft-lbs for the 2008 to 2010 model years.
- Tighten in a star (criss-cross) pattern so the wheel seats flat.
- Re-check torque after 50 to 100 miles.
- Aftermarket wheels or lug nuts can specify a different value - use the wheel maker's figure if it differs.
| Years | Torque | Pattern |
|---|---|---|
| 2008 to 2010 | 96-100 ft-lbs | Star pattern |
| 1995 to 1998 | 45-50 ft-lbs | Star pattern |
| Years | Thread size |
|---|---|
| 2004 to 2019 | 14mm x 1.50 bolt |
The guide below does not break out the Bentley Brooklands separately - this is the general Bentley thread size, same source.
Seat type (cone, mag, or ball) and hex size are not given per vehicle by this source - match them to the lug nut already on your wheel before ordering locks. Source: White Knight Wheel Accessories - 2020 Application Guide.
Tools for the job
These fit any vehicle. Lug nuts and wheel locks are vehicle-specific, so that link searches by your Bentley Brooklands.
As an Amazon Associate we earn from qualifying purchases, at no extra cost to you.
How to torque Bentley Brooklands wheels
- Hand-thread every lug nut, then snug them lightly with the wheel off the ground.
- Lower the car until the tire just touches and cannot spin.
- Set the wrench to 96 to 100 ft-lbs and tighten in a star pattern, skipping to the opposite nut each time.
- Lower fully, go around once more at the same setting.
- Re-check after 50 to 100 miles.
Other Bentley models
Source: James Halderman - Lug Nut Torque Values 1995-2021. Torque values assume clean, dry threads and OEM wheels. Always confirm against your owner's manual, and re-check torque after the first 50 to 100 miles.